Toro Reelmaster 6500-D Service Manual page 36

C. High temperature shutdown switch (Fig. 30).
Glow plug bus (Fig. 31).
13.Make sure all cable ties securing the wiring harness,
fuel lines, or hydraulic hoses to the engine are removed.
14.Connect hoist or lift to the front and rear engine lift
tabs.
15.Remove the nuts, washers, and cap screws securing
the engine brackets to the engine mounts.
One person should operate lift or hoist while the
other person guides the engine out of the ma-
chine.
IMPORTANT: Make sure not to damage the engine,
fuel and hydraulic lines, electrical harness, or other
parts while removing the engine.
16.Slowly lift engine up and out the rear of the machine.
Engine Installation (Fig. 25)
1. Connect hoist or lift to the front and rear engine lift
tabs.
One person should operate lift or hoist while the
other person guides the engine into the machine.
IMPORTANT: Make sure not to damage the engine,
fuel and hydraulic lines, electrical harness, or other
parts while installing the engine.
2. Position engine slowly from the rear of the machine.
3. Secure the engine brackets to the engine mounts.
4. Disconnect hoist or lift from engine.
5. Connect wires and/or electrical connections to the
following electrical components:
A. Glow plug bus (Fig. 31). High temperature shut-
down switch (Fig. 30).
B. Battery, frame, and wire harness ground to the
engine block and the ETR solenoid (Fig. 29).
C. The temperature sender (Fig. 28). The oil low
pressure switch, starter, and alternator (Fig 27).
Kubota Diesel Engine
CAUTION
CAUTION
(shown with hydraulic filter & bracket removed)
1. Battery & frame ground
2. ETR solenoid
1. High temperature shutdown switch
2
3
1. Glow plug wire
2. Rear injection nozzle
6. Install hydraulic oil filter and bracket and connect hy-
draulic lines.
7. Connect throttle cable to the cable clamp and swivel
on the speed control lever (Fig. 26).
8. Connect hydraulic lines at hydraulic pump assembly.
9. Connect all fuel hoses.
Page 3 - 22
2
1
3
Figure 29
3. Wire harness ground
1
Figure 30
1
Figure 31
3. Fuel hose
Reelmaster 6500-D/6700-D