Toro Reelmaster 6500-D Service Manual page 291

5. Check that roller brush has light contact with rear roll-
er (Fig. 46). If contact is incorrect, brush operation will
be adversely affected. Also make sure that brush shaft
is parallel with rear roller.
6. Lubricate grease fittings on brush housings until
grease purges past inboard seals. Wipe excess grease
from seals and fittings.
Reelmaster 6500--D/6700--D
1
1. Driven pulley
2. Drive pulley
2
1. Rear roller brush
2. Rear roller
Page 7.2 - - 39 Rev. E
STRAIGHT EDGE
Figure 44
3. Check for alignment
Figure 45
1
Figure 46
3. Light contact
DPA Cutting Units
2
3
3