Temperature Sender - Toro Reelmaster 6500-D Service Manual

Hide thumbs Also See for Reelmaster 6500-D:
Table of Contents

Advertisement

Temperature Sender

The sender is located on the left side of the water flange
that is attached to the front of the engine cylinder head.
There is a blue/white wire attached to the terminal of the
switch (Fig. 35).
1. Lower coolant level in the engine and remove the
high temperature sender.
2. Put switch in a container of oil with a thermometer
and slowly heat the oil (Fig. 36).
Handle the hot oil with extreme care to prevent
personal injury or fire.
Note: Prior to taking resistance readings with a digital
multi meter, short the test leads together. The meter will
display a small resistance value (usually 0.5 ohms or
less). This resistance is due to the internal resistance of
the meter and test leads. Subtract this value from from
the measured value of the component you are testing.
3. Check resistance of the sender with a multimeter
(ohms setting) as the temperature increases.
A. The meter should indicate from 54 to 78 ohms at
200_F (93.3_C).
B. Replace sender if specification is not met.
4. Install sender to the water flange.
A. Clean threads of water flange and sender
thoroughly. Apply Permabond #LH150 sealant or
equivalent to the threads of the water flange.
B. Screw sender into the water flange and tighten.
C. Connect blue/white wire to sender. Apply skin-
over grease to sender terminal.
5. Fill engine cooling system (see Check Cooling Sys-
tem in Chapter 3 - Kubota Diesel Engine).
Reelmaster 6500-D/6700-D
CAUTION
Page 5 - 29
2
Figure 35
1. Temperature sender
Figure 36
Electrical System (Rev. C)
1
2. Alternator

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Reelmaster 6700-d038060380703808

Table of Contents