Toro Reelmaster 6500-D Service Manual page 285

Removal (Figs. 31 and 32)
1. Remove retaining ring from both ends of roller.
2. Support roller assembly and press one end of roller
shaft to remove seals and bearing from opposite end of
roller. Press on other end of roller shaft to remove re-
maining seals and bearing from roller. Be careful not to
drop roller shaft or tube when removing seals and bear-
ings.
3. Discard removed seals and bearings.
Installation (Figs. 31 and 32)
Note: Use of a press is recommended to assemble
the roller. If a press is not available, a soft face hammer
can be used with the special tools to assemble the roller.
1. Use installation tool TOR4065 and handle TOR4073
to install inner oil seal into each end of roller tube. Apply
grease to ID of seal after installation.
2. Install bearings into roller tube:
A. Use tool TOR4066 and handle TOR4073 to
install bearing into one end of roller.
B. Install roller shaft from opposite end of roller. Be
careful not to damage the inner oil seals when instal-
ling shaft.
C. Put roller in a vertical position and support shaft
and installed bearing with tool TOR4067.
D. Use tool TOR4067 to install second bearing.
3. Use tool TOR4068 to install inner seal.
4. Use tool TOR4069 to install outer seal.
5. Install retaining ring.
6. Use tool TOR4071 to install outer oil seal.
7. Use tool TOR4067 to install roller washer.
8. Put opposite end of roller facing up and support bot-
tom end with tool TOR4067. Repeat steps 3 through 7.
9. Use a hand operated grease gun and No. 2 general
purpose lithium base grease to lubricate bearings until
grease appears at roller washer. Wipe off excess
grease.
Reelmaster 6500--D/6700--D
1. Roller tube
2. Roller shaft
3. Inner oil seal
4. Grease fitting
5. Ball bearing
Page 7.2 - - 33 Rev. E
Figure 32
6. Inner seal
7. Outer seal
8. Retaining ring
9. Outer oil seal
10. Roller washer
DPA Cutting Units