Toro Reelmaster 6500-D Service Manual page 236

12. Insert steering pin into the pivot knuckle if you wish
to keep cutting units locked in a straight line during op-
eration. If no steering pin is used, the cutting units will
steer themselves as the traction unit turns (Fig. 40).
13. Hook spring wire around bottom of steering pin
(Fig. 40).
14. Mount the motor to the drive end of the cutting unit
and secure with two capscrews provided (Fig. 41).
Cutting Units Page 7 - 26
2
1
Figure 41
1. Motor
2. O-ring
Reelmaster 6500-D/6700-D