Run (Etr) Solenoid (Solenoid With 3 Wire Connector) - Toro Reelmaster 6500-D Service Manual

Run (ETR) Solenoid (Solenoid With 3 Wire Connector)

The solenoid must be energized for the engine to run. It
is mounted on the engine block near the injection pump.
In Place Testing
Note: Prior to taking small resistance readings with a
digital multimeter, short the test leads together. The me-
ter will display a small resistance value (usually 0.5
ohms or less). This resistance is due to the internal re-
sistance of the meter and test leads. Subtract this value
from from the measured value of the component you are
testing.
1. Disconnect the connector from the solenoid.
2. Using a digital multimeter, touch one lead to the pin
of the black wire and the other lead to the pin of the
orange/red wire. The resistance of the pull coil should
be about 0.33 ohms.
3. Using a digital multimeter, touch one lead to the pin
of the black wire and the other lead to the pin of the red/
blue wire. The resistance of the hold coil should be
about 12.2 ohms.
4. Connect solenoid to the wiring harness.
Live testing
1. Disconnect connector from the solenoid.
Note: The solenoid may be removed from the engine
or tested in place.
2. If the solenoid is removed from the engine, make
sure that the solenoid plunger moves freely and is free
of dirt, debris, and corrosion.
Note: When testing run solenoid, use test leads with
at least 14 gauge wire.
3. Connect a positive (+) test lead from a 12 VDC
source to the pins of the red/blue and orange/red
wires.
4. Touch a negative (-) test lead from the 12 VDC
source to the pin of the black wire. The solenoid should
engage making an audible "click".
5. Remove positive (+) voltage from the pin of the
orange/red wire. The solenoid should stay engaged.
6. Remove positive (+) voltage from the pin of the red/
blue wire. The solenoid should release.
7. Reconnect the wires to the solenoid.
Reelmaster 6500-D/6700-D
(shown with hydraulic filter & bracket removed)
3
1. Cap screw
2. Fuel stop solenoid
3. Gasket
Page 5 - 25
1
Figure 27
7. ETR solenoid
6
5
2
1
Figure 28
4. Common (Black wire)
5. Hold coil (Red/blue wire)
6. Pull coil (Orange/red wire
Electrical System (Rev. C)
4