Toro Reelmaster 6500-D Service Manual page 227

Removal
6. Loosen bedknife adjusting knob to loosen bedknife to
reel contact.
7. Loosen locknut on bedknife adjuster assembly and
disengaging adjuster from bedbar (Fig. 25).
8. Remove bedbar leveling screw from L.H. side of cut-
ting unit.
9. Remove fasteners securing L.H. and R.H. bedbar
pivot hubs to frame.
10. Remove bedbar assembly.
11. Remove capscrew, washer and quad ring from R.H.
end of bedbar.
12. Remove R.H. and L.H. pivot hubs from bedbar.
13. Sharpen or replace bedknife as necessary (see
Bedknife Replacement and Grinding).
Installation
1. Inspect bedbar end bushings and flange bushings for
wear and replace if necessary.
2. Install R.H. and L.H. pivot hubs onto bedbar.
3. Install quad ring, washer and capscrew to R.H. end of
bedbar.
4. Install bedbar onto cutting unit and secure pivot hubs
to frame with fasteners removed in step 4 above.
5. Install bedbar leveling capscrew and nuts to L.H. side
of cutting unit.
6. Install bedknife adjusting knob assembly. Tighten
locknut to compress spring to dimension shown
(Fig. 26).
7. Adjust bedknife to reel (see Bedknife to Reel Adjust-
ment).
Reelmaster 6500-D/6700-D
2
1. Bedknife Adjusting Knob
2. Locknut
Page 7 - 17
1
Figure 25
1.25 in. (32 mm)
Figure 26
Cutting Units