Assembly; Reel Motor (Bosch) - Toro Reelmaster 6500-D Service Manual

Hide thumbs Also See for Reelmaster 6500-D:
Table of Contents

Advertisement

Assembly (Fig. 40)
1. Put flange on a flat surface with shaft seal facing
down. Make sure back side of flange is free of contami-
nation.
2. Put front bearing block, seal side down, on flange.
3. Apply a light coating of oil to exposed face of bearing
block. Put tape or seal protector tool (TOR4072) over
splined end of drive shaft. Insert drive shaft through
bearing block and shaft seal.
4. Put idler gear on bearing block. Apply a light coating
of oil to back face of drive and idler gears.
5. Put rear bearing block, seal side up, on drive and
idler gear shafts.
6. Install the two front dowel pins in the flange.

Reel Motor (Bosch)

7
3
4
19
1. Rear Cover
2. Drive Gear
3. Seal
4. Washer (if used)
5. Pressure Seal
6. Back- -up Ring
7. O- -ring
Hydraulic System
11 to 15 ft- -lb
(15 to 20 N- -m)
8
12
2
6
9
14
5
11
Figure 42
8. Body
9. Idler Gear
10. Cap Screw (4 used)
11. Front Flange
12. Dowel Pin
13. Rear Bearing Block
Page 4 - 70
7. Carefully install gear housing over rear bearing block
and slide gear housing down over the gears and front
bearing block. Make sure the markings put on the flange
and housing earlier line up.
8. The rear bearing block should sit just below back
face of gear housing. If bearing block sits higher that rear
face of housing, remove gear housing and check that E-
seal or O-ring did not shift out of place during assembly.
9. Install remaining two dowel pins in rear of gear hous-
ing, then put end cover on back of motor.
10.After motor has been assembled, tighten capscrews
by hand. Tighten the capscrews evenly in a crossing
pattern to 40 to 45 ft-lb (54 to 61 N- -m).
11. Put a small amount of hydraulic oil in port on motor
and rotate driveshaft one revolution. Protect the shaft if
using a pliers. If drive shaft binds, disassemble motor
and repeat assembly process.
18
17
16
7
13
5
12
Rev. E
35 to 40 ft- -lb
(47 to 55 N- -m)
15
10
15
16
17
1
6
18
11 to 15 ft- -lb
(15 to 20 N- -m)
14. Front Bearing Block
15. O-ring
16. O-ring
17. Back- -up Ring
18. Relief Cartridge
19. Retaining Ring
Reelmaster 6500-D/6700-D

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Reelmaster 6700-d038060380703808

Table of Contents