Toro Reelmaster 6500-D Service Manual page 258

Cutting Unit Tool Kit
Toro Part Number: TOR4070
This tool kit includes special tools required for rebuilding
the cutting unit and cutting unit drive motor on the
Reelmaster 6500--D/6700--D series of machines.
TOR4064 Spanner Wrench (not used on DPA)
TOR4065 Inner Oil Seal Installer
TOR4066 Bearing Installer
TOR4067 Shaft Support Tool
TOR4068 Inner Seal Installer
TOR4869 Outer Seal Installer
TOR4071 Outer Oil Seal Installer
TOR4072 Reel Motor Shaft Seal Protector
TOR4073 Handle
TOR4074 Spline Insert Tool (9 tooth)
Rear Roller Bearing and Seal Installation Tools
These tools are used to assemble the cutting unit roller
that has greasable bearings and a bearing nut used to
retain the bearings.
115--0852 Inner Seal Tool
115--0853 Bearing/Outer Seal Tool
107--8133 Bearing Installation Washer
Turf Evaluator Tool
Toro Model Number: 04399
Many turf discrepancies are subtle and require closer
examination. In these instances, the Turf Evaluator
grass viewing tool is helpful. It can assist turf managers
and service technicians in determining causes for poor
reel mower performance and in comparing the effective
height--of--cut of one mowed surface to another. This
tool should be used with the Toro Guide to Evaluation
Reel Mower Performance and Using the TurfEvaluator
(Toro part no. 97931SL).
DPA Cutting Units
Inner Seal
Tool
Page 7.2 - - 6 Rev. E
Figure 8
Bearing Installation
Washer
Bearing/Outer Seal
Figure 9
Figure 10
Reelmaster 6500--D/6700--D
Tool