Speedometer Sensor Replacement - Toro Reelmaster 6500-D Service Manual

Speedometer Sensor Replacement

1. Thread locknut onto speed sensor to allow full expo-
sure of sensor threads.
2. Center a motor piston with the center of the sensor
port (see Sensor Port View in Figure 52 below). NOTE:
Use a suitable tool to feel when a motor piston is in the
center of the sensor port.
3. Lubricate O-ring on sensor.
4. Thread sensor into port until sensor contacts piston.
Motor output shaft must rotate freely 360
5. Turn sensor out (counter-clockwise) until sensor
orientation grooves are at a right angle + 3
centerline, then back out sensor one full turn or 360
Hold sensor at this position and tighten locknut to a
torque of 75 - 125 in-lb (8.5 - 14.1 N- -m).
Orientation
Grooves
Speed Sensor
Piston
SENSOR SIDE VIEW
Reelmaster 6500-D/6700-D
o
.
o
to motor
o
.
Sensor Port
Lock Nut
Figure 52
Page 5 - 41
1
Figure 51
1. Speedometer sensor
SENSOR PORT VIEW
Sensor Port
Piston
CORRECT
POSITION
SENSOR INSTALLATION
o o
90 to 93
Electrical System (Rev. C)
Rev. F
Piston
INCORRECT
POSITION
Motor
Centerline
Orientation
Grooves