Toro Reelmaster 6500-D Service Manual page 269

9. To make an adjustment to the cutting units while
backlapping, turn reels OFF by moving the Lower Mow/
Raise lever rearward; move the Enable/Disable switch
to Disable and turn the engine OFF. After adjustments
have been completed, repeat steps 5--8.
10.When the backlapping operation is completed, run a
file across the front face of the bedknife. This will remove
any burrs or rough edges that may have built up on the
cutting edge.
11. Repeat procedure for all cutting units to be backlap-
ped.
12.When backlap operation has been completed, return
the backlap levers (or knobs) to the forward flow posi-
tion, lower seat and wash all lapping compound off cut-
ting units. Adjust cutting unit reel to bedknife as needed.
Note: If the backlap levers (or knobs) are not returned
to the forward flow position after backlapping, the cutting
units will not raise or function properly.
Reelmaster 6500--D/6700--D
Relief Angle
Page 7.2 - - 17 Rev. E
Top Face
Remove
Burr
Front
Face
Front Angle
Figure 18
DPA Cutting Units