Greasing The Steering Head Bearing; Removing The Front Fender; Installing The Front Fender; Removing The Shock Absorber - KTM 250 EXC-F 2013 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.18

Greasing the steering head bearing

11.19

Removing the front fender

11.20

Installing the front fender

11.21

Removing the shock absorber

–
Mount and tighten screw
Guideline
Screw, top steering stem
Finishing work
–
Check the steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
x
(EXC-F SIX DAYS)
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
(EXC‑F EU, EXC‑F AUS, XCF‑W)
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
–
Remove screws
–
Make sure the spacers remain in place.
101345-10
–
Ensure that the spacers are mounted in the fender.
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
Info
Make sure the holding lugs engage in the start number plate or headlight
mask.
101345-10
x
Preparatory work
–
Raise the motorcycle with the lift stand. (
Main work
–
Remove screw
without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
absorber.
101444-10
.
2
M8
(
x
( p. 51)
x
(
x
( p. 49)
x
. Remove the front fender.
1
and lower the rear wheel with the swing arm as far as possible
1
, push splash protector
2 3
17 Nm Loctite
(12.5 lbf ft)
p. 52)
p. 44)
p. 48)
p. 47)
.
1
M6 10 Nm (7.4 lbf ft)
p. 44)
to the side, and remove the shock
54
® 243™