FIBRE-to-SAS/SATA RAID SUBSYSTEM
2. Select the RAID level to be created. Currently RAID levels 0, 1, 5, 6 and 10 are
available.
NOTE: To create a RAID 10, select multiples of two disks and select
RAID 1. The RAID Level will still show as "RAID 1" but the RAID
capacity is correct.
3. Enable 'Write Cache' if you want the controller to respond with Good status when
the data is written to the cache, but before it is written to disk.
4. Enable 'Read Cache' if you want the controller to store the data most recently
retrieved in the cache.
5. Enable 'Read Ahead' if you want the controller to optimize performance on
sequential reads.
6. Enable 'Disk Caching' if you want the controller to enable disk caching.
76
User Manual