For SES2 board PRO-90-5601:
a. To upgrade proSES firmware, connect RS232 cable (Phone-Jack to DB9) from
RS232 port of SES module to available serial port of your PC.
b. Open "HyperTerminal" in your Windows PC and setup as follows:
Settings
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
c. To access the SES console, press <ENTER> at least once to verify the SES
console session has been established (a "-->" prompt should appear if
configured properly).
d. At the prompt, type "proses upgrade", followed by <ENTER>.
115200 (for SES board PRO-90-5601)
8
None
1
None
FIBRE-to-SAS/SATA RAID SUBSYSTEM
User Manual
151