Table of Contents
Advertisement
2.1.3 Controller Module Installation
In this section, you will be shown how to install the Controller Module.
a. Check for damage, especially to the connectors at the rear of the Controller
Module.
CAUTION! Handle the module with care and avoid damaging the
connectors. Do not install the module if the connectors are
damaged.
b. With the Controller handle in the open position, carefully insert the module into
the enclosure.
c. Manually close the handle to complete the Controller Module installation.
d. Tighten the thumb screws on the handle to secure the Controller Module to the
enclosure.
FIBRE-to-SAS/SATA RAID SUBSYSTEM
User Manual
15
Advertisement
Table of Contents
