FIBRE-to-SAS/SATA RAID SUBSYSTEM
2.1.4 Controller Board Replacement
NOTE: It is necessary to use ESD anti-static device when handling
sensitive parts of the controller module.
1. Remove the two SFP modules from the FC ports.
2. Loosen the thumb screws. Raise the controller handle until the controller
module moves out of the slot.
3. Hold the controller handle and pull out the controller module.
4. Release the memory module lock and remove the memory module.
5. Unscrew two hex nut screws at the SAS expansion port.
6. Remove six screws at the bottom of the controller module. Note that there are
six hex jack screws supporting the controller board to the module case.
7. Remove the hex nut screws.
8. Unscrew four screws that hold the two heat sinks on the side of the controller
module.
9. Remove the controller module.
2.1.5 Upgrading Controller Firmware
NOTE: For upgrading the controller firmware, please refer to
Administration chapter, Update Firmware section.
16
User Manual