Table of Contents
Advertisement
FIBRE-to-SAS/SATA RAID SUBSYSTEM
For PRO-90-6601 SES board:
NOTE: The upgrade process is done twice. The first time needs a
jumper in JP8. The second time does not need a jumper.
1. Power off the RAID system. Remove the SES Module. Insert a jumper in JP8 of
SES board PRO-90-6601.
2. Insert the SES module into the RAID subsystem. Connect RS232 serial cable to
the RS232 port of SES module.
3.
Power on RAID subsystem. Configure terminal settings as follows:
Baud Rate:
Data Bits:
Parity:
Stop Bits:
Flow Control:
4.
Open terminal console. Type "proses upgrade".
28
User Manual
38400
8
None
1
None
Advertisement
Table of Contents
