Table of Contents
Advertisement
FIBRE-to-SAS/SATA RAID SUBSYSTEM
For PRO-90-6601 SES board:
NOTE: The upgrade process is done twice. The first time needs a
jumper in JP8. The second time does not need a jumper.
a. Power off the RAID system. Remove the SES Module. Insert a jumper in JP8
of SES board PRO-90-6601.
b. Insert the SES module into the RAID subsystem. Power on RAID subsystem.
c. Connect RS232 cable (Phone-Jack to DB9) from RS232 port of SES module to
available serial port of your PC.
d. Open "HyperTerminal" in your Windows PC and setup as follows:
e. To access the SES console, press <ENTER> at least once to verify the SES
console session has been established (a "-->" prompt should appear if
configured properly).
f.
At the prompt, type "proses upgrade", followed by <ENTER>.
154
User Manual
Settings
Baud Rate
38400 (for SES board PRO-90-6601)
Data Bits
8
Parity
None
Stop Bits
1
Flow Control
None
Advertisement
Table of Contents
