Table of Contents
Advertisement
FIBRE-to-SAS/SATA RAID SUBSYSTEM
9.7 Update Firmware
The Administration
installed on the system.
Steps to Update Firmware:
1. In the Administration
select the file containing the firmware.
2. The installation will begin when the 'Upgrade' button is clicked.
3. Do not perform any other actions until a message is displayed confirming
that the installation is finished.
4. If a system reset is needed to run the new firmware, you will be prompted
to do so at this point.
WARNING: This facility should only be used under the direction of
our technical support team.
WARNING: Upgrading the controller could take several minutes to
complete. It is recommended to stop all access to the system.
132
User Manual
Upgrade Firmware screen allows new firmware to be
Upgrade Firmware screen, click 'Browse' and
Advertisement
Table of Contents
