FIBRE-to-SAS/SATA RAID SUBSYSTEM
4.
Hard Contact Relay
5.
System Light
a. The System Light is used to indicate whether the SES Module is on and
whether or not there is an error.
b. A blinking
functioning normally.
c.
A steady
error with the SES Module.
2.3.3 SES Module LED
2.3.4 SES Module Installation
This section describes how to install the SES Module.
a. Check for damage, especially to the PCB Golden Fingers at the rear of the SES
Module.
CAUTION! Handle the module with care and avoid damaging the
Golden Fingers. In addition, make sure there are no fingerprints on
the Golden Fingers. Do not install the module if the Golden Fingers
are damaged.
22
User Manual
GREEN
light indicates that the SES Module is ON and
GREEN
light or no GREEN light indicates that there is an