5.2 Items to Check Before Turning ON the Power
Before turning ON the power to the system incorporating the pulse output unit, check the
following points.
(1) Checking connections of each device
Check to make sure that each device has been connected as indicated by the design.
(2) Checking the installation of the external safety circuit
Check to make sure the safety circuit (wiring and installation of over limit switch) based on the
external circuit has been installed properly.
(3) Checking the installation of the safety circuit based on the pulse output unit
Check the connections between the pulse output unit and over limit switches.
Check the installation condition of the over limit switches.
(4) Checking the settings for power ON sequence
Make sure settings have been entered so that power supplies will be turned on according to
the procedure outlined in section "Procedure for Turning ON the Power".
(5) Checking the CPU mode selection switch
Set the GM1 Controller to the STOP mode. Setting it in the RUN mode can cause inadvertent
operation.
WUME-GM1PG-01
5.2 Items to Check Before Turning ON the Power
5-3