Items To Check During Wiring; Power On Operation - Panasonic GM1 Series User Manual

12.2 Checking Safety Circuit Design

12.2.2 Items to Check during Wiring

■
System configuration example
(1) Checking connections of each device
Check whether each device has been connected as indicated by the design.
(2) Checking the installation of an external safety circuit
Check that the safety circuit is installed as an external circuit by installing and wiring over limit
switches properly.
(3) Checking the settings for power ON sequence
Check whether settings have been configured so that the power is turned on in sequence.
(4) Checking the GM1 Controller mode selector switch
Set the GM1 Controller to STOP mode. Setting to RUN mode can cause unexpected
operation.

12.2.3 Power ON Operation

When turning ON the power to the system incorporating the GM1 Controller, follow the power
ON sequence described in the procedure below.
● Consider the performance and statuses of any external devices connected to the system,
and take sufficient care so that turning ON the power will not initiate unexpected
movements.
12-4 WUME-GM1ETCSU-01