FUTABA T10PX Full Manual page 163

Alarm and Vibrator function setup
1
(Limit adjustment)
Tap the " Limit] or "
" [
the screen.
Use the [+] or [-] button to adjust the limit value.
2
(Alarm and vibrator function setup)
Tap the " " [Alarm] type and select [Inhibit], [Buzzer]or
"/ "
[Voice].
"Inhibit": No audible alarm/ "Buzzer": Audible alarm/ "Voice": Voice alarm
Tap the " " [Vibrator] type and select [Inhibit], [Type 1],
"/ "
[Type 2], or [Type 3].
"Inhibit": No active vibration
"Type 1": Continuous vibration
"Type 2": Intermittent vibration for a long time
"Type 3": Intermittent vibration for a short time
3
(Speech function setup)
Tap the "Voice" (ON) or (OFF) to select ON/OFF.
"OFF": No voice guide
"ON": Information loaded by voice
4
When finished, return to the Telemetry screen by pressing the HOME button.
Reset consumption capacity display
Unless the reset button of SBS-01C is pressed, the consumption capacity measured by SBS-
01C is maintained and displayed as "integrated capacity" on the screen. If you wish to mea-
sure the consumption capacity for one run, it is possible to reset the consumption capacity
display on the transmitter by the next operation. However, the record of the integrated capac-
ity of the SBS-01C main body cannot be reset by the function which resets the transmitter
display.
1
(Reset operation)
Tap the [Reset], the consumption capacity display is reset to "0". The
consumption capacity from the time of reset is displayed until you
reset it again. If you reset the consumption capacity by pressing the
reset button of SBS-01C, the consumption capacity display on the
transmitter is also reset.
2
When finished, return to the Telemetry screen by pressing the
HOME button.
The reset operation on the transmitter resets the integrated capacity display on the T10PX. It does not re-
set the integrated capacity on the SBS-01C. The consumption capacity measurement range of SBS-01C
is 32767 mAh maximum. When this value is exceeded, the consumption capacity display on the transmit-
ter is also reset automatically. Depending on the timing, reset may occur during measurement. Therefore,
make sure to reset the integrated capacity on the SBS-01C before the integrated capacity display reach-
es 32767 mAh.
TELEMETRY MENU
Limit]. Value input buttons appear on
" [
163
Adjustment buttons
- Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Setting
- Tap alarm type.
Inhibit/Buzzer/Voice
Setting
- Tap Vibrator type.
Inhibit/Type 1/Type 2/Type 3
Setting
- Tap (ON)/(OFF).
*The voice guide loading inter-
val is set by sensor menu.
Return to table of contents