Condition - FUTABA T10PX Full Manual

ample, there are two types of data: Steering D/R is set to 90% in the normal state, and
Steering D/R is set to 80% in the second state. This " Condition " can be set for each
model.
- To use the " Condition " function, switch or trim (dial) setting by the " Switch select "
function or " Trim/Dial select " function (Linkage menu) is necessary.
- It is possible to name the condition.
- First, the initial settings of each condition 2 to 4 functions are created.
- Switching from the current condition to another condition by switch set by switch
select function is indicated by an audible alarm, and the condition number is displayed
in the upper on the screen. (The steering switch and the trigger switch are non-audible
alarms.)
-The functions that can be set at each condition are displayed by condition number at
the top of the menu screen. Since the reverse function, end point, and other model stan-
dard setup menus are not posted by condition number, all conditions set are common.
-The data set at condition 2 to 4 is memorized until reset by data reset (Model menu).
switch by the " Switch select " function is changed.
Home screen
Condition function ON/OFF
1
(Function ON/OFF)
Tap mode (ON) or (OFF) to select ON/OFF.
"OFF": Function OFF
"ON": Function ON
LINKAGE MENU

Condition

Menu screen
Menu-1
Linkage menu screen
Menu-2
Return to table of contents
92
Condition
Setting
- Tap (ON)/(OFF).
Tap to turn on.
When the condition function is
turned on, the condition copy
display becomes active and the
condition is enabled.
-