Digital Trim Operation; Microsd Port And Usb Port - FUTABA T10PX Full Manual

Digital Trim Operation

(Initial settings: DT1: Steering trim, DT2: Throttle trim, DT3: Channel 3, DT4: Channel 4, DT5: Steering D/R, DT6: ATL-Brake rate)
Operating by the trim: Push the trim lever to the left or right (up or down). The cur-
rent position is displayed on the LCD screen.
DT2
DT4
• Each step is indicated by a tone.
• When the trim exceeds the maximum trim adjustment range, the beep will change and the servo will not move
any farther.
• When the steering wheel is neutral, adjust the steering trim so that the car goes straight without curving left
and right.
• Adjust the throttle trim so that the car stops when the throttle trigger is in neutral so that the brake will not be
applied when the throttle trigger is released during operation.
• Steering D/R :The steering left and right servo travels are adjusted simultaneously.
• ATL: Decreases the set value when the braking effect is strong and increases the set value when the braking
effect is weak.
• DT1-DT4 returns to neutral with long press
Steering And Throttle Trim Operation
travel. This prevents the linkages from binding when adjustments are made.

microSD port And USB port

microSD port
T10PX model data and telemetry log data can be
saved by using a commercial microSD card. When
T10PX software updates are released, the microSD
card can also be used to make the update.
USB port
The transmitter can be used as a game controller
by connecting it to a computer with a USB cable.
(Some games cannot be used.)
DT1
DT3
• 1/3-DT1 (Steering trim display)
• 2/4-DT2 (Throttle trim display)
• 5-DT3 (Channel. 3 display)
• 6-DT4 (Channel. 4 display)
• 7-DT5 (Steering D/R display)
• 8-DT6 (ATL display)
13
DT5
DT6
1
2
3
4
5
6
Rotating the antenna 90 ° reveals
two ports.
USB-C
Return to table of contents
7
8
microSD