Angle Spacer - FUTABA T10PX Full Manual

Angle Spacer

The wheel mounting angle can be changed by using the optional angle spacer 5°.
- The angle spacer use the included four M2x5 mm hex screws.
- Obtain hex wrench. / Remove the battery.
- The length of the screws used at each part differs. When reassembling the steering wheel unit,
always use the specified screws.
Angle spacer
Adjust the angle with the position mark.
1
2
3
Four M2x5 screws for
angle spacer mounting
Angle spacer
M2×19
M2×10
M2×6
M2×19
M2×10
M2×6
M2×19
- Use the accessory screws and the transmitter screws.
- There are extra screws in the accessories.
- M2 x 5 screws are special size so be careful not to lose them.
- Do not overtighten M2×19 four screws.
28
APA uses the outside holes. The
mounting angle in the direction
of rotation can be adjusted.
Normal
screw
position
Scre Screw mounting point
Screw mounting point
Return to table of contents
M2×5
M2×5
M2×5