FUTABA T10PX Full Manual page 73

Telemetry function ON/OFF
1
(Function ON/OFF)
Tap telemetry (ON) or (OFF) to select ON/OFF.
"OFF": Telemetry function OFF
"ON": Telemetry function ON
2
When finished, return to the Linkage menu screen by pressing the HOME button.
S-FHSS/FASST Receiver Link
1
Bring the transmitter and the receiver close to each other,
within 20 inches (half meter).
2
Turn on the power switch (PWR). On the display (DSP) side,
you cannot link.
3
Turn on the receiver.
4
Push the push switch of the receiver.
When the link is complete, the LED in the receiver changes to solid green. Check the
operation of the servo.
Precaution:
If there are many Futaba 2.4GHz systems turned on close to your receiver might not link to your transmitter. In
this case, even if the receiver's LED stays solid green, unfortunately, the receiver might have established a link
to one of the other transmitters. It is dangerous if you do not notice this situation. To avoid problems, it is strongly
recommended that you double-check that the transmitter controls the receiver by making the wheel or trigger
inputs and checking the servo response.
*Please refer to the table below for LED status vs receiver's condition.
LED status vs receiver's condition:
No signal reception
Receiving signals
Receiving signals, but ID is unmatched.
Unrecoverable failure (EEPROM,etc.)
*1: LED could be changed to red during intermittently during data processing.
LINKAGE MENU
73
Telemetry function ON
Red: On
Green: On
*1
Green: Blink (T-FHSS, Red: On)
LED: Red and Green turn on alternately
Return to table of contents
Setting
- Tap (ON)/(OFF).