Removal Of Trigger Unit - FUTABA T10PX Full Manual

Removal Of Trigger Unit

The trigger can be removed to replace the trigger spring.
How to remove
1
Remove the fixing screw shown in the
figure with a hex wrench.
Be careful not to lose the screws.
Note:
Be careful not to damage the case or
to remove.
Be careful not to pinch the wiring
when assembling.
2
Remove the 2 steering unit mounting
screws (M3x12 screw).
Remove the 2 mounting screws com-
pletely from the transmitter body.
3
Next, Remove the two M3x12 screws
and one M2x6 screw on the rear unit.
Remove the 3 mounting screws com-
pletely from the transmitter body.
4
Pull out the trigger unit in the direction
of the black arrow while opening the
case slightly in the direction of the white
arrow.
Be careful not to cut the wiring.
Assembly
Insert the groove of the
trigger into the rail and
slide it in.
Trigger groove and
transmitter case rail
Note: Trigger unit is difficult to remove
Trigger
Rail for trigger unit
Transmitter
case
16
M3×12
M3×12
1. While pulling down
the trigger unit
2. Pull out the trigger
unit slowly
Return to table of contents
M2×8
M2×8
M2×8
M2×8
M3×12
M2×6
M3×12
Trigger unit