Kyosho Mini-Z Evo Dedicated Receiver - FUTABA T10PX Full Manual

Kyosho Mini-Z EVO dedicated receiver RA-42
1
Display the "Receiver setting" screen from the "Linkage
menu" or "User menu". Set the system to "Mini-Z T-FHSS".
Bring the transmitter and the receiver close to each other,
within 20-inches (half a meter). Turn on the Mini-Z receiver
RA-42.
2
Touch [Link] on the transmitter T10PX screen, you will hear a
chime sound, and T10PX will enter the link mode for 20-sec-
onds.
3
Push the receiver side push switch for about 2-seconds or
more.
4
Release the Link SW. The LED will solid for 2-seconds and
then blink.
Tap the [Close] button on the link screen of
the transmitter to cancel the link mode.
5
The LED on the receiver will stay solid, when completed.
Warning
After the linking is done, please cycle receiver power and check if the receiver to be linked is really under
the control of your transmitter.
In this case, even if the receiver's LED stays solid green, unfortunately, the receiver might have established a link to one of the other trans-
mitters. This is very dangerous if you do not notice this situation. In order to avoid the problem, we strongly recommend you to double-
check whether your receiver is really under control by your transmitter by giving the stick input and then checking the servo response.
Do not perform the linking procedure with the motor's main wire connected or the engine operating as it
may result in serious injury.
Push
switch
LED
Return to table of contents
39