When Using Optional Battery; Nimh Life Battery Replacement Method - FUTABA T10PX Full Manual

When Using The Optional Battery
When using an optional rechargeable battery, replace the battery as described below.
-Always use the optional FT2F1100B, FT2F1700B, FT2F2100B, HT5F1800 or LT-
2F2000B rechargeable battery. *Products for Europe cannot use NiMH / LiFe batteries.
-The type of power source used must be selected through the system setting.
-When the transmitter will not be used for a long time, remove the battery.
NiMH LiFe Battery Replacement
Method
1
Refer to the previous description and remove
the transmitter battery cover.
2
After removing the dry cell battery box from the
transmitter, disconnect the connector.
Caution
If you remove the dry cell battery box from the trans-
mitter, replace it carefully with the wiring on the same
side as before. Reinstalling the battery box in the op-
posite direction could cause the wires to be discon-
nected.
3
Insert the connector of the new battery and load
the new battery into the transmitter.
Store the battery wiring in
this groove.
4
Finish by installing the battery cover.
Caution
When closing the battery cover, be careful that the battery cover does not pinch the battery lead
wires.
Shorting of the battery lead wires may lead to fire and abnormal heating and cause burns or fire disaster.
Connect to the connector
on this side.
19
Battery cover
Slide battery cover while pressing here.
Return to table of contents
7.26