FUTABA T10PX Full Manual page 194

Reverse cancel
MC401,402CR/MC950CR/MC940,960CR :ACT/INH
Same as Link software Reverse Cancel.
When set to "ACT", the reverse
operation is not performed.
Robot mode
MC401,402CR/MC950CR/
MC940,960CR :ACT/INH
Same as Link software Robot
Mode.
When set to "ACT", brake opera-
tion is not performed, there is only
forward and reverse operation.
Brake slope
MC940,960CR/:0~300
Same as Link software Brake Slope.
This function adjusted the braking effect when the throttle was returned
(throttle off). It cancels operation like on actual vehicles engine brake.
Brake timer
MC940,960CR/MC950CR :0sec~300sec
Same as Link software Brake Timer.
When the reverse function is used, ordinarily, if the trigger is not moved to
the brake (reverse) side and then returned from the brake operation position to the neutral
position, the reverse operation not perform. However, when used by intentionally moving the
neutral point to the forward side, if brake operation is repeated, the reverse operation may
be performed even if the trigger is not returned to the neutral position. The time required to
switch to reverse operation can be set to prevent this from occurring was returned (throttle
off). It cancels operation like that called engine brake of actual vehicles.
Lead angle
MC950CR/:0~1500
Same as Link software Lead Angle.
The lead angle of the motor can be set at the MC950CR side.
However, we recommend that it usually be set to "0" since this setting is
premised on the setting by referring to the speed log by the Link software.
ACCESSORY MENU
MC401,402CR
194
MC940,960CR
MC940,960CR
Return to table of contents
MC950CR
MC950CR