Mid-Mounting in a Two-Post Rack System
To mount the chassis in a two‐post rack system, perform the following steps:
1.
Attach brackets to the chassis as shown in Figure
a.
b. Align the holes (B) in the bracket with the tabs (C) on the chassis and place the bracket
c.
d. Fasten the bracket to the chassis using screw (D).
e.
Figure 2-8
A. Chassis bracket in mid-mount position
B. Bracket holes
C. Chassis tabs
D. #6-32 x 3/16-inch screw
2.
Attach L brackets to center posts as shown in Figure
a.
b. Attach the L bracket to the center post using the screws (B) supplied with your rack. Do
c.
Place a mounting bracket (A) along one side of the chassis in the mid‐mount position.
against the chassis.
Slide the bracket toward the front of the chassis to the end of travel.
Repeat step a through step d to attach a bracket to the other side of the chassis.
Installing a Chassis Bracket in the Mid-Mount Position
Position an L bracket (A) on the backside of the center post (C).
not fully tighten at this time.
Repeat step a and step b to attach an L bracket to the other center post.
Mid-Mounting in a Two-Post Rack System
2‐8.
2‐9.
RBT-8100 Wireless Switch Installation Guide 2-7
C
B
D
A