Abs Warning Light; Vehicle Dynamics Control Warning Light/Vehicle Dynamics Control Operation Indicator Light - Subaru Forester 2013 Owner's Manual

Hide thumbs Also See for Forester 2013:
Table of Contents

Advertisement

3-20
Instruments and controls/Warning and indicator lights
NOTE
. If the tire pressures are not correct
and/or the tires are not all the same
size and brand, the rear differential will
be heavily loaded when the vehicle is
driven, resulting in an abnormally high
oil temperature.
. The rear differential oil will deterio-
rate if its temperature increases en-
ough for the rear differential oil tem-
perature warning light to illuminate. It is
advisable to have the rear differential
oil replaced as soon as possible.
&

ABS warning light

CAUTION
. If any of the following conditions
occur, we recommend that you
have the ABS system repaired at
the first available opportunity by
your SUBARU dealer.
– The warning light does not
illuminate when the ignition
switch is turned to the "ON"
position.
– The warning light illuminates
when the ignition switch is
turned to the "ON" position,
but it does not turn off even
when the vehicle speed ex-
ceeds approximately 40 km/h
(25 mph).
– The warning light illuminates
during driving.
. When the warning light is on (and
the brake system warning light is
off), the ABS function shuts
down. However, the conventional
brake system continues to oper-
ate normally.
The ABS warning light illuminates to-
gether with the brake system warning light
if the EBD system malfunctions. For
further details of the EBD system mal-
function warning, refer to "Electronic
Brake Force Distribution (EBD) system
warning" F3-22.
NOTE
If the warning light behavior is as
shown in the following, the ABS sys-
tem may be considered normal.
. The warning light illuminates when
the ignition switch is turned to the
"ON" position and turns off approxi-
mately 2 seconds after the engine has
started.
. The warning light illuminates right
after the engine is started but turns off
immediately, remaining off.
. The warning light remains illumi-
nated after the engine has been started,
but it turns off when the vehicle speed
reaches approximately 40 km/h (25
mph).
. The warning light illuminates during
driving, but it turns off immediately and
remains off.
When driving with an insufficient battery
voltage such as when the engine is jump
started, the ABS warning light may illumi-
nate. This is due to the low battery voltage
and does not indicate a malfunction.
When the battery becomes fully charged,
the light will turn off.
&
Vehicle Dynamics
Control warning light/
Vehicle Dynamics Con-
trol operation indicator
light
! Vehicle Dynamics Control warning
light
CAUTION
The Vehicle Dynamics Control sys-
tem provides its ABS control
through the electrical circuit of the
ABS system. Accordingly, if the ABS
is inoperative, the Vehicle Dynamics

Advertisement

Table of Contents
loading

Table of Contents