At Oil Temp Warning Light (At And Cvt Models); Abs Warning Light - Subaru Outback 2011 Owner's Manual

3-22
Instruments and controls
position but the engine is not running:
approximately 3.8 liters (4.0 US qt, 3.3
Imp qt)
. while the engine is running: approxi-
mately 5.3 liters (5.6 US qt, 4.7 Imp qt)
If the engine low oil level warning light
illuminates while driving, park the vehicle
at a safe and level location, and then
check the engine oil level. When the
engine oil level is not within the normal
range, refill with engine oil if necessary.
Refer to "Engine oil" F11-18.
If the warning light does not turn off after
refilling with engine oil or the warning light
illuminates even though the engine oil
level is within the normal range, we
recommend that you have the system
checked by a SUBARU dealer.
NOTE
. The engine low oil level warning
light will not turn off immediately even
if you replace or add engine oil. It will
turn off only when the vehicle is idling
and the engine is warmed up comple-
tely.
. When the vehicle is considerably
inclined on an uphill or steep slope, the
warning light may illuminate tempora-
rily due to the movement of engine oil
in the engine.
&
AT OIL TEMP warning
light (AT and CVT mod-
els)
The AT oil temperature warning light "AT
OIL TEMP" illuminates when the ignition
switch is turned to the "ON" position and
turns off after the engine has started.
If this light illuminates when the engine is
running, it may indicate that the transmis-
sion fluid temperature is too hot.
If the light illuminates while driving, im-
mediately stop the vehicle in a safe place
and let the engine idle until the warning
light turns off.
! Transmission control system warn-
ing
If the "AT OIL TEMP" warning light flashes
after the engine has started, it may
indicate that the transmission control
system is not working properly. We re-
commend that you contact your nearest
SUBARU dealer for service immediately.
&

ABS warning light

The ABS warning light illuminates when
the ignition switch is turned to the "ON"
position and turns off after approximately 2
seconds.
This is an indication that the ABS system
is working properly.
CAUTION
. If any of the following conditions
occur, we recommend that you
have the ABS system repaired at
the first available opportunity by
your SUBARU dealer.
– The warning light does not
illuminate when the ignition
switch is turned to the "ON"
position.
– The warning light illuminates
when the ignition switch is
turned to the "ON" position,
but it does not turn off even
when the vehicle speed ex-
ceeds approximately 12 km/h
(8 mph).
– The warning light illuminates
during driving.
– The warning light flashes.
. When the warning light is on (and
brake system warning light is
off), the ABS function shuts
down; however, the conventional
brake system continues to oper-
ate normally.
. When the warning light is flash-
ing, the ABS system may be