Drive Switches - Subaru Forester 2013 Owner's Manual

7-24
Starting and operating/SI–DRIVE
& SI-DRIVE switches
NOTE
If any of the SI-DRIVE indicators blink,
the SI-DRIVE system may be malfunc-
tioning. We recommend that you con-
tact your SUBARU dealer.
! Models with Sport Sharp (S#) mode
SI-DRIVE switches
To select the Intelligent (I) mode, perform
either of the following procedures.
. Press the "S/I" switch when the Sport
(S) mode is selected
. Press the "S#/I" switch when the Sport
Sharp (S#) mode is selected
To select the Sport (S) mode, press the "S/
I" switch when any mode other than Sport
(S) mode is selected.
To select the Sport Sharp (S#) mode,
press the "S#/I" switch when any mode
other than Sport Sharp (S#) mode is
selected.
NOTE
. The next time you turn on the
engine, after you turned off the engine
in the Sport Sharp (S#) mode, the SI-
DRIVE mode changes to the Sport (S)
mode.
. The next time you turn on the
engine, after you turned off the engine
in the Sport (S) mode or Intelligent (I)
mode, the SI-DRIVE mode will stay in
the same mode as when the engine
was turned off.
. While the engine is running, if the
malfunction indicator light/CHECK EN-
GINE warning light illuminates, the SI-
DRIVE mode changes to the Sport (S)
mode. In this case, it is not possible to
change to the Sport Sharp (S#) mode or
Intelligent (I) mode.
. If there is a possibility that the
engine could overheat because of a
temperature increase of the engine
coolant, it is not possible to change to
the Sport Sharp (S#) mode. While the
vehicle is in the Sport Sharp (S#) mode,
it changes to the Sport (S) mode when
the engine coolant temperature in-
creases.
! Models without Sport Sharp (S#)
mode
SI-DRIVE switches
To select the Intelligent (I) mode, press the
"I" switch. To select the Sport (S) mode,
press the "S" switch.