Abs Warning Light - Subaru Outback 2016 Manual

ing for approximately one min-
ute. This indicates the TPMS is
unable to monitor all four road
wheels. We recommend that you
contact your SUBARU dealer as
soon as possible for tire and
sensor replacement and/or sys-
tem resetting. If the light illumi-
nates steadily after blinking for
approximately one minute, we
recommend that you promptly
contact a SUBARU dealer to have
the system inspected.
CAUTION
The tire pressure monitoring system
is NOT a substitute for manually
checking tire pressure. The tire
pressure should be checked peri-
odically (at least monthly) using a
tire gauge. Change the TPMS mode
according to the specified pressure
shown on the tire inflation pressure
label. After any change to tire pres-
sure(s), the tire pressure monitoring
system will not re-check tire infla-
tion pressures until the vehicle is
first driven more than 40 km/h (25
mph). After adjusting the tire pres-
sures, increase the vehicle speed to
at least 40 km/h (25 mph) to start the
Instruments and controls/Warning and indicator lights
TPMS re-checking of the tire infla-
tion pressures. If the tire pressures
are now above the severe low
pressure threshold, the low tire
pressure warning light should turn
off a few minutes later. Therefore, be
sure to install the specified size for
the front and rear tires.
&

ABS warning light

CAUTION
. If any of the following conditions
occur, we recommend that you
have the ABS system repaired at
the first available opportunity by
your SUBARU dealer.
– The warning light does not
illuminate when the ignition
switch is turned to the "ON"
position.
– The warning light illuminates
when the ignition switch is
turned to the "ON" position,
but it does not turn off even
after the vehicle is started.
– The warning light illuminates
during driving.
. When the warning light is on (and
brake system warning light is
off), the ABS function shuts
down; however, the conventional
brake system continues to oper-
ate normally.
The ABS warning light illuminates to-
gether with the brake system warning light
if the EBD system malfunctions. For
further details of the EBD system mal-
function warning, refer to "Electronic
Brake Force Distribution (EBD) system
warning" F3-23.
NOTE
If the warning light behavior is as
shown in the following, the ABS sys-
tem may be considered normal.
. The warning light illuminates right
after the engine is started but turns off
immediately, remaining off.
. The warning light remains illumi-
nated after the engine has been started,
but it turns off during driving.
. The warning light illuminates during
driving, but it turns off immediately and
remains off.
When driving with an insufficient battery
voltage such as when the engine is jump
started, the ABS warning light may illumi-
nate. This is due to the low battery voltage
– CONTINUED –
3-21