Immobilizer Indicator Light; Drive Indicator Light (If Equipped); Shift-Up Indicator Light (Mt Models) - Subaru Forester 2013 Owner's Manual

3-30
Instruments and controls/Warning and indicator lights
&
Immobilizer indicator
light
This light begins flashing under any of the
following conditions.
For models with "keyless access with
push-button start system":
. Immediately after the push-button igni-
tion switch is turned to the "OFF" position.
. Immediately after the driver's door is
opened or closed when the push-button
ignition switch is in the "ON" or "ACC"
position.
For models without "keyless access
with push-button start system":
. Approximately 60 seconds after the
ignition switch is turned from the "ON"
position to the "ACC" or "LOCK" position.
. Immediately after the key is pulled out.
If the indicator light does not blink, it may
indicate that immobilizer system is not
working properly. We recommend that you
contact your nearest SUBARU dealer
immediately.
In case an unauthorized key is used, the
immobilizer indicator light illuminates.
NOTE
Even if the immobilizer indicator light
flashes irregularly or its fuse blows (the
light does not flash if its fuse is blown),
the immobilizer system will function
normally.
& SI-DRIVE indicator light (if
equipped)
1) Sport (S) mode
2) Intelligent (I) mode
3) Sport Sharp (S#) mode (if equipped)
This light indicates the current SI-DRIVE
mode.
For details of SI-DRIVE mode, refer to "SI-
DRIVE" F7-22.
&
Shift-up indicator light
(MT models)
While driving, this indicator light illumi-
nates and informs the driver about the
upshift timing for fuel-efficient driving.
The shift-up indicator can be activated or
deactivated by performing the following
procedure.
1. Turn the ignition switch to the "LOCK"/
"OFF" or "ACC" position.
2. Press the trip knob to show "
" " on the trip meter display.
The display can be switched as shown in
the following sequence by pressing the
trip knob.
" or