Subaru Forester 2013 Owner's Manual page 290

5-38
Audio/Hands–free system
! Preparation for using the Hands-
free system
! When no cell phones are regis-
tered
Before using the Hands-free system, it is
necessary to register a cell phone in the
system. Perform the following procedure
to register a cell phone.
1. Press the OFF hook switch
– "WELCOME!" will be displayed.
2. Press the "TUNE/TRACK" dial or the
talk switch .
3. Perform either of the following proce-
dures.
– Select the "RECORD NAME"
menu.
– Press the talk switch
4. Say the name (voice tag) to be
registered.
5. Select the "CONFIRM" menu by oper-
ating the "TUNE/TRACK" dial.
– After "CAR M_MEDIA" is displayed,
a pass key will be displayed.
6. Input the displayed pass key into the
cell phone while "PKY: ****" is displayed.
– If you input the correct pass key,
"PAIRED" will be displayed and the
registration procedure will be finished.
– If you input an incorrect pass key,
"FAILED" will be displayed and the
registration procedure will not be
successful.
! Registering a cell phone
To register a cell phone to the in-vehicle
equipment, perform the following proce-
dure.
1. Select the "SETUP" menu.
2. Select the "PHONE SETUP" menu.
.
3. Select the "PAIR PHONE" menu.
4. Perform either of the following proce-
dures.
– Select the "RECORD NAME"
menu.
– Press the talk switch
5. Say the name (voice tag) to be
registered.
.
6. Select the "CONFIRM" menu by oper-
ating the "TUNE/TRACK" dial.
– After "CAR M_MEDIA" is displayed,
a pass key will be displayed.
7. Input the displayed pass key into the
cell phone while "PKY: ****" is displayed.
– If you input the correct pass key,
"PAIRED" will be displayed and the
registration procedure will be finished.
– If you input an incorrect pass key,
"FAILED" will be displayed and the
registration procedure will not be
successful.
! Selecting a cell phone
To select the registered cell phone for
connecting to the in-vehicle equipment,
perform the following procedure.
1. Select the "SETUP" menu.
2. Select the "PHONE SETUP" menu.
3. Select the "SELECT PHONE" menu.
– If no cell phones are registered,
"EMPTY" will be displayed and the
mode will change to the "PHONE
SETUP" mode.
4. Select the cell phone by performing
either of the following procedures.
– Operate the "TUNE/TRACK" dial.
. – Press the talk switch
the voice tag.
5. Select the "CONFIRM" menu.
– "SELECTED" will be displayed, the
selected cell phone will be connected
to the in-vehicle equipment and the
mode will change to the "PHONE
SETUP" mode.
– If the selected cell phone cannot be
connected, "FAILED" will be displayed
and the mode will change to the
"PHONE SETUP" mode.
and say