Viewing Component States - Nortel 1002rp Maintenance And Diagnostics

Using CallPilot Manager to monitor hardware

Viewing component states

View a component state to determine the general condition of the
component, including whether the component is disabled or off duty.
The component state is shown in the Maintenance section of the
Maintenance screen.
Component states
You can determine the state of a component by looking at the State box
in the Maintenance section.
State
Active
Disabled
Idle
InTest
Loading
Local (Red) Alarm
No resources
76
Description
The component is working and currently involved in
processing a call.
The diagnostic failed.
The component is working but not currently
involved in processing a call.
A diagnostic is running on the resource or device.
The component has been started, which takes it out
of the Off Duty state.
This state occurs quickly and is immediately
followed by Idle.
A Receive Loss of Synchronization error occurred
on incoming data over a T1 link and lasted more than
2.5 seconds. This condition will exist until
synchronization is recovered and remains recovered
for 12 seconds.
The hardware required for the component to operate
is not installed or is not operating properly.
Standard 1.11
CallPilot