Replacing The Pentium Iii Sbc Card - Nortel 1002rp Maintenance And Diagnostics

January 2007

Replacing the Pentium III SBC card

Use system diagnostic tools and refer to error codes to determine
whether the SBC card should be replaced. This section provides
instructions for replacing the SBC card.
Requirements
Before you replace the SBC card, gather the following tools:
one Phillips-head screwdriver
one antistatic wrist strap
the replacement SBC card
cable labels
SBC card connectors and jumpers
Figure 43 on page 202 shows the location of connectors where cables
must be disconnected or connected as part of the procedure to replace the
SBC card. The jumpers shown in this diagram are used in the BIOS
configuration procedures
1002rp Server Maintenance and Diagnostics
Maintaining the Pentium III SBC card
201