Starting And Stopping Components - Nortel 1002rp Maintenance And Diagnostics

January 2007

Starting and stopping components

When you stop a component, you take it out of service and prevent it
from operating. You must stop a component before you can replace it (if
the component is replaceable) or run a diagnostic test on it.
To bring an out-of-service component back into service, you must start
it.
Start and stop components from the Maintenance section on the
Maintenance screen.
ATTENTION
1002rp Server Maintenance and Diagnostics
Nortel recommends that, if possible, you courtesy stop a
component. Courtesy stop is available only at the
individual channel level.
To courtesy stop CallPilot, use the following:
Multimedia Monitor - to courtesy stop a range of
multimedia channels
Channel Monitor - to courtesy stop a range of call
(DS30X, also known as DS0) channels
Using CallPilot Manager to monitor hardware
79