To Run The Tracert Command From Windows - Nortel 1002rp Maintenance And Diagnostics

Using Windows online diagnostic tools
Tracert syntax
The tracert command uses the following syntax:
tracert [-d] [-h maximum_hops] [-j host_list]
Tracert parameters
the following table shows the tracert parameters.
Table 4: Tracert parameters
Parameter
-d
-h maximum_hops Specifies the maximum number of hops to search
-j host-list
-w timeout
target_name

To run the tracert command from Windows

1 Click Start
Result: The Command Prompt window appears.
2 At the Command prompt, type the following command:
tracert [-d] [-h maximum_hops] [-j host_list] [-w timeout]
[target_name]
Example: tracert 200.286.0.32
3 Press Enter.
42
[-w timeout] [target_name]
Description
Specifies not to resolve addresses to hostnames.
for the target.
Specifies a loose source route along the host list.
Waits the number of milliseconds specified by the
timeout for each reply.
Specifies the name of the target host.
➝
Programs
➝
Accessories
Standard 1.11
➝
Command Prompt.
CallPilot