Replacing The Status Display Panel - Nortel CallPilot 1002rp Installation And Configuration Manual

October 2002

Replacing the status display panel

Locating the display
The display is located at the front of the chassis and is cabled to the rear of
the chassis and the alarm board.
To replace the status display panel
1 Power off the server.
2 Remove the top cover and the front bezel from the chassis.
3 Remove the cooling fans (see "Replacing the cooling fan" on page 131).
The cooling fans block the access to the status panel.
Part 5: 1002rp Server Maintenance and Diagnostics
Replacing basic chassis components
141