Table of Contents
Advertisement
System Status and Messages
Several types of messages and indicators are displayed on the Acquisition Workstation screens to inform
you of the system and subsystem operational status as well as error messages. The complete list of error
messages is available in the Service Manual.
Expose Hold
The Expose Hold button (Figure A2-8) appears at the bottom of the Worklist or Acquisition screens when
there is some condition that prevents an x-ray from being taken, such as exam is open or the protocol is
not selected.
Press the Expose Hold button to view a list of all errors and interlocks that are preventing the exposure
(Figure A2-8). The items are removed from the list as they are corrected. The Expose Hold button
disappears when all errors and interlocks are corrected.
Figure A2-8 Worklist and Acquisition screen Expose Hold button
Figure A2-9 Example system Inhibits list
System Status Area
System status messages are displayed on the bottom of all main Workstation screens (Figure A2-10).
System Status messages are displayed when the system detects an irregularity in system operation. The
message informs you when remedial action is required to correct the situation.
A console beep announces the arrival of an informational message. There are situations where a system
condition is detected that does not require stopping the procedure. The message tells you to Continue or
to Continue/Call Service (continue and call service).
NOTE: To clear the system status area, open the Message Log (described below) and close it again.
Definium AMX 700 X-Ray System
Operator Manual
5161515-1EN
Rev. 6 (10 February 2008)
© 2008 General Electric Company. All rights reserved.
Chapter A2: General Information
A2-10
Advertisement
Table of Contents
