Table of Contents
Advertisement
Refresh
Some systems are configured to automatically refresh the Worklist with data from the HIS/RIS on a
regular basis (such as every 10 minutes). However, if your system does not automatically refresh—or you
want to refresh the list before the scheduled time—you are able to refresh the list manually.
For mobile units, Refresh only functions when the unit is connected to the network. If the unit is not
connected to the network, pressing the [REFRESH] button only displays the current Worklist data.
The Refresh feature also removes any filtering that has been applied. Refer to
information.
Manual Refresh
Follow this process to manually refresh the Worklist.
1. Press [REFRESH] on the Worklist.
The Worklist updates with HIS/RIS data and removes any filtering.
NOTE: Refresh does not remove locally added procedures.
NOTE: You will not be able to make selections or access Worklist functions while the Worklist is refreshing.
Auto Refresh
The Auto Refresh interval is set on the Preferences – Worklist screen in System Utilities. Refer to
Chapter A7: Set Preferences-Worklist
When the system auto refreshes, a message (Figure A3-7) appears: "Auto Refresh in progress. Please
wait." The message remains until the refresh process is complete.
NOTE: You will not be able to make selections or access Worklist functions while the Worklist is refreshing.
Figure A3-7 Auto refresh message
Definium AMX 700 X-Ray System
Operator Manual
(p. A7-13) for more information.
5161515-1EN
Rev. 6 (10 February 2008)
© 2008 General Electric Company. All rights reserved.
Chapter A3: Worklist
Filter List
(p. A3-8) for more
A3-11
Advertisement
Table of Contents
