Software Reset - GE Definium AMX 700 Operator's Manual

NOTE: Do not obstruct the antenna by covering it with metal, such as a lead apron. This will affect the
signal strength.
The wireless icon appears on the bottom of the Worklist, Image Acquisition, Image Viewer, and Image
Management screens. The icon shows wireless status (on or off) and the signal strength as described in
Table A2-1.
Table A2-1 Wireless signal strength states
Icon
"X" only – Wireless feature
disabled
No colored bars, no "X" – No signal
1 red bar – Extremely Low signal
2 yellow bars – Low signal

Software Reset

A software reset switches the unit between wired and wireless network connection. That is, the unit will
automatically choose the wireless connection if the cable is not connected; if the cable is connected, the
unit will choose the wired connection.
NOTE: Software reset does not require Shutdown or a System Reset.
Follow this process to perform a software reset.
1. Connect or disconnect the network cable as appropriate.
2. On the Worklist or Image Management screen, press [UTILITIES].
The System – System screen (Figure A2-7) appears.
Figure A2-7 System – System screen with Software Reset button
Definium AMX 700 X-Ray System
Operator Manual
Description
5161515-1EN
© 2008 General Electric Company. All rights reserved.
Chapter A2: General Information
Icon
3 yellow bars – Good signal
4 green bars – Very Good signal
5 green bars – Excellent signal
Rev. 6 (10 February 2008)
Description
A2-8