Image Processing; Change Default Factory Looks For Exams - GE Definium AMX 700 Operator's Manual

Image Processing

The Image Processing preferences allow you to change which look is the default for the anatomical view.
Image Processing Preferences also allow you to view the settings of default factory looks or to create up
to five (5) custom looks.
NOTE: Custom looks and the default looks mapping can be backed up by having GE Service personnel
perform a system backup. It is recommended that a system backup be performed after any change
to the default looks mapping or when custom looks are built. Ask your GE Service personnel to
perform the system backup at their next visit. GE Service personnel can restore the settings from
the backup, if necessary.
Figure A7-22 Preferences – Image Processing

Change Default Factory Looks for Exams

The Default Factory Looks screen (Figure A7-23) allows you to change the default processing setting for
all 34 representative anatomical views, and then map this change to related anatomical views. Note that
this may over-ride existing default settings.
At the initial applications setup, the radiologist chooses the default look for each anatomical view.
Application specialists assign the looks to the system.
Follow this process to change the default factory looks.
1. From the Worklist screen, press [UTILITIES].
2. Select Preferences > Image Processing.
Definium AMX 700 X-Ray System
Operator Manual
5161515-1EN Rev. 6 (10 February 2008)
© 2008 General Electric Company. All rights reserved.
Chapter A7: Set Preferences
A7-31