Unpacking And Installation Instructions For M35-M Version - Kodak HEALTH SCIENCES MINILOADER 2 Plus Low Voltage Stand-Alone Installation Instructions Manual

II 3420

UNPACKING AND INSTALLATION INSTRUCTIONS FOR M35-M VERSION.

NOTE :- A 5 or 6 amp fused supply should be provided for the MINILOADER.
1. The MINILOADER is in the smaller of the two PACKING CASES, the larger CASE contains the
STAND for the MINILOADER and the parts for the M35-M.
2. Remove the BANDING from the larger PACKING CASE and lift the CARTON off the PALETTE.
3. Unpack and check all the parts. The CASE should contain :-
PART QUANT.
30015562 8
30015569 1
30015612 2
30015655 4
30015669 2
30015691 1
30025836 4
30025838 4
30025842 7
30025843 8
30026148 1
30026149 1
30026151 1
30026155 1
30026162 1
30026172 6
30026180 1
30026205 1
30026206 1
30026252 1
30025253 1
30026254 1
30026255 1
4. In the position where the MINILOADER is to stand, (the rear of the STAND is the open end), level the
STAND using the JACKING SCREWS leaving a gap of approximately 15 mm between the floor and
the bottom of the STAND. See FIGURE 1.
5. Unpack the M35-M PROCESSOR, remove the LID, FRONT PANEL, and the two SIDE PANELS.
Unscrew the STAND-BY OVERRIDE BUTTON from the REAR PANEL (leave the wires connected).
Remove the REAR PANEL, disconnecting the EXHAUST HOSE from the EXHAUST ADAPTOR.
Remove the EXHAUST ADAPTOR, and the PANEL FIXING SCREWS and RETAINING
WASHERS from the REAR PANEL and keep. Discard all PANELS.
© Kodak Ltd.
DESCRIPTION
COUNTERSUNK SCREWS M4x12 - (FOR PROCESSOR PANEL FIXING)
PLAIN WASHER M4 - (LEFT HAND PROCESSOR PANEL FIXING)
NUT M4 - (LEFT HAND PROCESSOR PANEL FIXING)
SCREW, HEXAGONAL, M8x20 - (FASTENING MINI. TO THE STAND)
STAR WASHER M4 - (FAN GRID GROUNDING)
SCREW M4x12 - (LEFT HAND PROCESSOR PANEL FIXING)
STAR WASHER M10 - (USED TO GROUND M35-M TO PLINTH)
STAR WASHER M8 - (USED TO GROUND MINILOADER TO STAND)
CUP WASHER M4 - (FOR PROCESSOR PANEL FIXING)
CAGED NUT M4 - (FOR PROCESSOR PANEL FIXING)
STAND ASSY. - (FOR MINILOADER)
FRONT PANEL ASSY. - M35-M
REAR PANEL ASSEMBLY - M35-M (INCLUDES 30026153 & 30026157)
DRIER EXIT PLATE - M35-M
PLINTH - M35-M
RETAINING BLOCKS
PROCESSOR LIGHT BAFFLE
M35-M TRANSPARENT PANEL - LEFT
M35-M TRANSPARENT PANEL - RIGHT
M35-M TRANSPARENT PANEL - FRONT
M35-M FAN GRID
BRACKET, M35-M TRANSPARENT PANEL RIGHT, RETAINING
PLATE, M35-M MAINS SWITCH PROTECTING
INSTALLATION INSTRUCTIONS
Page II-4 January 1995