Kodak HEALTH SCIENCES MINILOADER 2 Plus Low Voltage Stand-Alone Installation Instructions Manual page 14

II 3420
8.
Remove the following PACKING PROTECTIONS :-
a) The two RUBBER TIES that restrain the two SUCKER BARS.
b) The packing BLOCKS under the TWO SUCKER BARS.
c) The protection PACKING from the FILM EXIT CHUTE.
d) The TIE-WRAP from the MAGAZINE INJECTOR BAR.
e) The TIE from the CASSETTE INJECTOR.
9.
In the two HOLES under the PROCESSOR FEED SLOT marked "X", install the two SCREWS M4 x
30, and the two THIN M4 NUTS as shown below in figure 15. Place one of the M4 LARGE
DIAMETER WASHERS on each SCREW.
Processor entry slot
X
© Kodak Ltd.
Figure 15
X
Page II-14
INSTALLATION INSTRUCTIONS
Processor
Screw
Thin nut
Miniloader
Nut
Washers
January 1995