Kodak HEALTH SCIENCES MINILOADER 2 Plus Low Voltage Stand-Alone Installation Instructions Manual page 8

Hide thumbs Also See for HEALTH SCIENCES MINILOADER 2 Plus Low Voltage Stand-Alone:

II 3420

14.

Mount the six aluminium RETAINING BLOCKS on the top of the PROCESSOR FRAME as shown in

FIGURE 5. Use the MINILOADER STAND as a guide to position the BLOCKS on the front of the

PROCESSOR.

25 mm

15.

Refit the EXHAUST ADAPTOR (removed in step 5) to the new PROCESSOR REAR PANEL using

the existing HARDWARE. Fit the new REAR PANEL to the PROCESSOR using the original

SCREWS etc. Connect the EARTH LEAD from the PANEL to the M35-M ELECTRICAL BOX as

shown in FIGURE 6.

16.

Refit the STAND-BY/RUN SWITCH. Reconnect the M35-M EXHAUST HOSE to the EXHAUST ADAPTOR.

Figure 6

Wash

Electrical box

INSTALLATION INSTRUCTIONS

215 mm

Fix

Dev

215 mm

New rear panel

Page II-8

Figure 5

Blocks mount this way up.

Earth lead

January 1995

Table of Contents